A gunite or shotcrete pool can be built to enable the leading-edge bar of the pool cover to retract underneath the lid. This is not an option for fiberglass or vinyl liner pools unless the lids are made very thin, which would risk cracking and breaking. It is rare to find a pool in Idaho built this way because most pool builders don’t know it exists, it requires modifications during construction, and it adds to the homeowner’s cost. It is also common for pool builders in Boise and the Treasure Valley to not share options with their customers because they want to control what is done on the job. At Enhanced Pools, we want to educate our customers, give them the options, and let them make an informed decision.
To achieve the appearance of the leading-edge bar of the pool cover retracting beneath the lid, certain modifications are required.
First, the lids must be made larger to cover the lead edge bar. When lids are made to cover the pool cover box, they are typically only large enough to cover the box’s opening. When they are made to enable the pool cover leading-edge bar to retract underneath, they must be made large enough to cover most or all of the lowered, tiled bond beam as well.
Second, the water level needs to be set 1″-2″ lower than usual, depending on the scenario. Dropping the water level may require the pool builder to dig the pool deeper if the pool depth is critical.
Third, the bond beam should be built differently from most pool bond beams. In this scenario, the front portion of the bond beam should be about the same height as the water level, while the back portion should be the same height as the top of the tile. Inexperienced pool builders have mistakenly tried to build this bond beam as a steep slope, which creates two problems. First, a steeply sloped bond beam won’t allow the lead edge bar to retract as far underneath the lid. Second, a bond beam with a steep slope acts like a ramp, allowing pool water to easily overflow into the pool cover box and be lost through the box’s drains.
There are more considerations for this style of lid including, the thickness and material of the back wall of the pool cover box, the thickness and material of the larger lids, slope or “fall” of the decking around the pool cover box, consistency of thickness of the pool cover lids, alignment of the pool cover lids with the coping, thickness of the pool wall between the pool and pool cover box, overhang of the coping material on the sides of the pool, height of the waterline tile, how to conceal the lids that extend beyond the coping, and on.
There are many considerations and modifications to enable a pool to use lids like this over the pool cover box. No pool builder in Boise, Eagle, Meridian, Star, or anywhere in the Treasure Valley builds lids like this except Enhanced Pools. You don’t want someone trying to build a pool with this feature that has never done it before; you need an expert, a specialist in this type of swimming pool construction.